Need metal roof installation in Waldwick? We come look first, tell you plainly what it needs, and put the price in writing before anything starts.
A metal roof is what Roofing Brothers is known for, and it has been since 2002. On a Waldwick home that means standing seam or exposed fastener panels set over sound decking and real underlayment, with the ridge, valley and eave trim cut and fit on site rather than forced out of a box.
Not every Waldwick roof needs the biggest job on the sheet. When we quote metal roof installation we tell you honestly whether a repair will hold, whether doing one section will do, or whether you are genuinely past that — and we would rather do the smaller job well.
Metal is our specialty, so if metal roof installation on your Waldwick home opens the door to standing seam or a panel roof, we will price that right alongside the shingle option and let you compare the real numbers side by side.
Four steps and no surprises. This is how we have done it since 2002.
Nothing gets ordered until you have a written price in hand and have settled on the color you actually want.
Where the decking is sound and there is only one layer, we can often go over the top on purlins. We tell you which one your house calls for.
Synthetic underlayment over the whole roof, ice and water shield in the valleys and at the eaves, then panels set square on the correct fastener spacing.
Then the yard gets picked up, the scrap gets hauled off, and a magnet goes over the drive before we pull out.
What comes up on just about every estimate for a job like this.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Waldwick homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Installed properly over sound decking, a metal roof should give a Waldwick home 40 to 60 years. Standing seam often goes longer because there are no exposed fasteners to work loose or leak.
Most Waldwick metal roof jobs land between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off is involved. Standing seam runs higher than exposed fastener panels. We measure before we quote and the estimate is free.
A straightforward Waldwick house is usually three to five days. A cut up roof with dormers, valleys and multiple pitches takes longer, because every panel and trim piece gets measured and fit on site.
Real feedback from homeowners we have worked for.
"Nice work on the roof and good communication throughout. I would have liked a little more warning about the dumpster arriving, but that is a small thing."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Our church needed a new roof and the budget was tight. They worked with us on it, did beautiful work, and finished before the fall revival."